- There are no more items in your cart
- Shipping
- Total €0.00
Brand: Hikelok
RF-M10-316
Ferrula posteriore, 10mm , 316 SS. Intercambiabile con: BFM10-316 , SS-10M4-1
Brand: Hikelok
FF-M10-316
Ferula anteriore, 10mm OD, 316 SS. Intercambiabile con: FFM10-316 , SS-10M3-1
Acquisizione dati
Brand: Labjack
LJTick-Vref-25
The LJTick-VRef is a Voltage reference accessory that outputs a stable 2.5V or 4.096V signal. These ticks are commonly used as an excitation voltage for various circuits. The IOA and IOB lines are pass-through terminals, and do not interact with the accessory in any way. VRef-25 Specs: Voltage: 2.5V Accuracy: ±0.08%, ±2mV Maximum load: 50mA Short...
Brand: Labjack
LJTICK-OUTBUFF
Increases the output current of the DAC outputs on LabJack devices. Can also be used for switched 3.3V when attached to a 3.3V digital I/O line. LabJack devices cannot output more than about 15mA on their DAC0 and DAC1 analog outputs, so this accessory is very helpful for users who want to increase that capability. One common application is to control the...
Brand: Labjack
LJTICK-INBUFF
Very low bias current (1pA) input buffer which can directly measure pH sensors (electrode type sensors) and other weakly driven or high source impedance signals. The analog inputs on our compatible DAQ products (U3, U6, UE9, T7, T4) have typical bias currents on the order of 20 nA, which is quite low, but the LJTick-InBuff reduces that dramatically. Only...
Brand: Labjack
LJTICK-INAMP
Signal-conditioning module provides two instrumentation amplifiers ideal for low-level signals such as bridge circuits (e.g. strain gauges) and thermocouples. Each amplifier converts a differential input to single-ended. The LJTIA has switches to choose from 5 gain settings (x1, x11, x51, x201, or custom) and two output voltage offsets. The 4-pin design...
Brand: Labjack
LJTICK-DAC
Accessorio per labjack, fornisce due uscite analogiche +/-10V da due uscite digitali